Download Process Management Toolkit User Manual

Appendix C: Release Notes
Installation notes
Version 2.0.6 installs over the previous version of PMT 2.0. It isn’t necessary to uninstall the previous
version first.
Version 2.0.5
Released April 21, 2008
Version 2.0.5 addresses the following:
 Ladders that had rungs of logic too large to fit on a single page would not print. The printing method
was overhauled to correct this and print ladders more efficiently.
 Analog registers were not being properly removed and/or recreated in the points list. PMT now
performs a complete rebuild of the points list each time a ladder check or install is performed. This
process is reflected with a “busy” progress bar at the bottom left of the PMT status bar.
 Q Points were not being properly added to the logic file. (This fix only applies to the PLC033.)
 A scaling error for analog points on the screen builder was corrected.
 A math error was corrected with the flow totalizer object.
 A condition that caused the PLC/RDP to intermittently crash when used as a Modbus TCP slave
device with HT3 was corrected.
Features added/supported in version 2.0.5
 The Radio Map was enhanced to support configuring multiple stations for radio emulation.
 A new field (Slave Device # ) was added to the settings section to support the new Modbus serial
slave function.
 Logic Builder has a new right click function that displays system variable addresses.
 RNA110’s are now updated via PMT. This is accomplished by selecting Update RNA from PMT’s
Network menu. This works similarly to the RDP/PLC update function. PMT obtains the update
from the DFS/OCS FTP server and then prompts the user for the IP address of the target RNA110
before installing the update.
Installation notes
Version 2.0.5 installs over the previous version of PMT 2.0. It isn’t necessary to uninstall the previous
version first.
Version 2.0 (Initial Release)
Released December 20, 2006
PMT 2.0 was developed to enhance the PMT user interface and create more efficient communications
between PMT and attached RDP/PLC products. PMT 2.0 replaces PMT version 1.0.
Important: PMT 2.0 will not work with the PLC033 or the RDP033 until they have been updated to
System Release 122006.
DFS-00509-011
197