Download ESX/ESXi 4.1 - User Manual

elx_mes0706: 0706 IOCB Abort failed - outstanding %d failed %d
DESCRIPTION: The driver did not recover all IO following a reset task management command
DATA: (1) outstanding IO count (2) number of unrecovered IO
ACTION: Reset call fails to. ESX tries to recover.
elx_mes0713: SCSI layer issued Device Reset (%d, %d) reset status x%x flush status x%x
DESCRIPTION: A device reset has completed on (tgt, lun). Status values are displayed.
DATA: (1) tgt (2) lun (3) task mgmt status (4) flush status
ACTION: None required.
elx_mes0714: SCSI layer issued bus reset
DESCRIPTION: The SCSI layer is requesting the driver to abort all I/Os to all targets on this adapter.
DATA: (1) ret
ACTION: Check the state of the targets in question.
elx_mes0718: Unable to dma_map single request_buffer: x%x
DESCRIPTION: The driver could not map a single virtual address to a dma address.
DATA: (1) dma mapping error
ACTION: None. The driver fails the IO back to ESX.
elx_mes0721: Device Reset rport failure: rdata <rdata>
DESCRIPTION: The reset of the Rport failed.
DATA: None
ACTION: None required.
elx_mes0724: I/O flush failure for context <cntx> on <tgt:lun> cnt x%x
DESCRIPTION: The I/O flush to the {LUN, TARGET or HOST} has failed.
DATA: (1) cnt of unrecovered IO
ACTION: None required. The reset is retried.
elx_mes0727: TMF <cmd> to TGT <TGT#> LUN <LUN#> failed (<ulpStatus>, <ulpWord[4]>)
DESCRIPTION: The task management command failed.
DATA: None
ACTION: None required. The TMF command gets retried.
elx_mes0748: Abort handler timed out waiting for abort to complete:ret <status> ID <target id>
LUN <lun id> snum <serial number>
DESCRIPTION: The abort handler timed out waiting for abort to complete.
DATA: None
ACTION: None required.
elx_mes0798 Device Reset rport failure: rdata x%p
DESCRIPTION: Driver failed a device reset - no rdata buffer
DATA:
ACTION: Software driver error. If this problem persists, report these errors to Technical Support
Drivers for VMware ESX/ESXi 4.1 - Troubleshooting Section
Page 52