Download OPERATOR`S MANUAL
Transcript
CAUTIONS: 1. Troubleshooting should be done by qualified personnel only. 2. Remember that a battery can cause serious damage if shorted. 3. There are no user serviceable parts, fuses or circuit breakers inside the SunSaver. 4. Observe all normal precautions when working with energized circuitry. 1. BATTERY IS NOT CHARGING a. Check the green LED indicator. The green CHARGING LED should be on if it is daytime. b. Check that the proper battery type (sealed or flooded) has been selected. c. Check that all wire connections in the system are correct and tight. Check the polarity (+ and –) of the connections. d. Measure the PV array open-circuit voltage and confirm it is within normal limits. If the voltage is low or zero, check the connections at the PV array itself. Disconnect the PV from the controller when working on the PV array. e. Check that the load is not drawing more energy than the PV array can provide. f. Check if there are excessive voltage drops between the controller and the battery. This will cause undercharging of the battery. g. Check the condition of the battery. Determine if the battery voltage declines at night with no load. If unable to maintain its voltage, the battery may be failing. h. Measure the PV voltage and the battery voltage at the SunSaver terminals. If the voltage at the terminals is the same (within a few tenths of volts) the PV array is charging the battery. If PV voltage is close to the open circuit voltage of the panels and the battery voltage is low, the controller is not charging the batteries and may be damaged. 2. BATTERY VOLTAGE IS TOO HIGH a. First check the operating conditions to confirm that the voltage is higher than specifications. Consider the temperature compensation of the controller’s PWM setpoint. For example, 14