Download Tips for Portable Cot Installation PC-06

Tips for Portable Cot Installation PC-06
1.
Please read the user manual before set up. Pull up the center part of the portable cot as high as possible, then
jerk up the side by side using the other hand. You will hear “Click” when the rail is locked. Push down the center
after all the sides are locked properly. According to the Manual.
If one side can’t be locked properly, Pull up the center part as high as possible, then use the other hand to press
the button on the side to release the locked rails till the center of the locked rail going down itself (Before the lock
released, Don’t push down the locked rail that will damage the lock). Release all the locks then try Step 1 again.
2.
Stick the Velcro on four corners and Hock the bassinet support.
z Hock the bassinet support
3. Put the metal pieces into small fabric pockets and join together
4. Put the portable mattress on the bassinet
5. Set up the Changing Table
6. Lock the changing table and canopy on the cot
Note: Canopy maybe need to be turned over before hock on the cot
7. Put Mosquito Net and buttoned
8. To unassembled the portacot, please remove the canopy, changing table and mattress support.
Then rotate the red handle at the centre of the bottom to unlock the central lock and raise the red handle. Cick the
side buttons to release the four side rails.
Please contact ALLBABY LIMITED, if you need any help:
Phone: 09 4473666
Mobile: 021 02778138
Email: [email protected]