Download Security Escort 2.15 Technical Reference Manual

118
en | Security Escort pager setup
6.5
Security Escort
Alarm area setup
In the Transponder Database under the File menu, select the transponder where the alarm
area is to be programmed in. Click the [Edit Data] button, followed by Show areas radio
button and select the desired area.
Figure 6.4: Transponder Area Edit Dialog
Number
Each transponder can have up to 80 areas defined in them (prior to version
2.04 of the software, only 40 areas could be defined). This area number
range from 0 to 79. Use the [Locate] button to define the area graphically on
the map.
Video Switcher Selects a system serial port that is programmed in the Remote Setup dialog.
The purpose is to display the area, where the alarm is most likely located, on
the CCTV monitors near the Central Console. The string would activate a
macro in the video switcher that selects the appropriate camera, and
controls any required zoom and tilt actions. Up to 40 characters may be
entered. Control characters may be entered as "^A" for control A.
2015.05 | V2.15.0 | DOC
Technical Reference Manual
Robert Bosch (SEA) Pte Ltd