Download Manual - 10

BC-2 Body Camera Diagram
Operation
Power On/Off
IR LEDs
Power On:
Power Indicator
Lens
Clamp Base
Recording Indicator
White Illumination LED
Light Sensor
1.5” LCD Screen
Water Tight Cover
for USB Port
Menu Selection
Menu Selection
Connector for
Radio Cable
Menu /
Confirm
1. Press and hold the “Power” button until the device beeps.
2. The LED Power Indicator will light up blue and the LCD screen will
display what the camera is currently viewing..
3. After a few minutes of inactivity, the system will then enter into
recording standby mode and the LED Recording Indicator will remain
lit.
4. The LCD screen will display the currently recording interface and
your body camera is ready to use.
Power Off:
PTT
Audio REC /
Menu Exit
1. Press and hold the “Power” button for at least three seconds.
Photo /
Menu Next
Video REC /
Menu Previous
USB
Water Tight Seal
Power
3.5 mm
Earphone Jack
Connector for
Radio Cable
2. The device will beep.
3. The current file will be saved to the internal storage and when both
indicator lights have turned off, the device is powered off.
When the recorder is in standby mode if there is no interaction with it for
more than thirty (30) seconds the LCD screen will turn off.
FIG. 1
Body Camera Diagram
The recorder will automatically power off when the battery is low.
12
13