Download User Manual - Projector Central

Replacing the projection lamp
The lamp hour timer in the About menu counts the number of hours the
lamp has been in use. Twenty hours before the lamp life expires, the message “Change lamp” appears on the screen at startup. If the maximum lamp
time is exceeded, the lamp will not light. In this case, after replacing the
lamp you must reset the lamp hours by simultaneously pressing both
Brightness buttons on the keypad and holding them for 10 seconds. You
can order new lamp modules from your dealer.
Lamp hours used
turn off and unplug
the projector
1 Turn off the projector and unplug the power cable.
2 Wait 60 minutes to allow the projector to cool thoroughly.
wait 60 minutes
3 Turn the projector upside down and remove the lamp door by removing
the two screws and sliding the lamp door tabs out of the three tab bays.
CAUTION: Never operate the projector with the lamp door removed.
This disrupts the air flow and causes the projector to overheat.
4 Loosen the captive screw on the lamp module.
loosen the screw on lamp module
bail wire
32