Download SimpleBGC Software User Manual

powered and turned on.
Status LED
There are 2 LEDs on board. Red led lights when the power for MCU is present. Green/blue LED signals
show actual state of the system:

LED is off — pause before calibration, to take hands off or to level gimbal.

LED blinks slowly – Calibration is in action. Freeze gimbal during this process.

LED blinks fast — system error, stabilization cannot be performed. To check error description,
connect to GUI.

LED blinks fast for short time – confirmation for user action.

LED is on — normal operation mode.

LED is on, but blinks irregularly – I2C errors appears. Check in the GUI I2C errors counter.
Also, additional LEDs may present to signal serial communication on RX and TX line.
© 2013-2014 Basecamelectronics®
15