Download TIMS Advanced Modules User Manual

Transcript
UWB MODULE
(ULTRA WIDEBAND PULSE GENERATOR)
Digital, TTL-level data presented at the two data inputs is output as distinct shaped pulses.
Each channel can output one of eight switch selectable pulse shapes, including three Gaussian
Pulses, four Modified Hermite Pulses and a predefined pulse (Sync Pulse). The two input
channels share the same digital clock.
Four switch selectable operating modes are available:
PPM: Pulse Position Modulation,
BPM: Bi-Phase Modulation,
OOK: On-Off-Keying, and
OPM: Orthogonal Pulse Modulation.
A fixed half bit width delay is also available.
User defined pulse shapes can also be implemented with data pre-programmed in EPROM.
INPUT
DIGITAL SIGNAL
DELAY INPUT
DIGITAL DELAY
OUTPUT
DELAY OUTPUT
MODE
SELECT
DUAL
OUTPUT
PULSE
GENERATOR
DIGITAL DATA 2
INPUT
PULSE
OUTPUT 2
DIGITAL DATA 1
INPUT
PULSE
OUTPUT 1
PULSE
OUTPUT 2
PULSE
OUTPUT 1
BLOCK DIAGRAM
CLOCK
INPUT
FRONT PANEL
USE
DATA INPUTS
DATA 1 and DATA 2 accept digital, TTL-level digital data where transitions must occur at the
positive edge of the CLK input.
CLOCK INPUT
The CLK input must be synchronised and in-phase with the data at DATA 1 and DATA 2
inputs.
DELAY INPUT and OUTPUT
The DELAY input accepts a digital, TTL-level data signal and outputs the digital, TTL-level
signal delayed by half a bit.
TIMS AMS1 User Manual 140