Download USER`S MANUAL
Transcript
13.With the help of a second person, hold the console assembly near the Handrails (79) (only one is shown). 13 Console Assembly Connect the ground wire from the console assembly to the Ground Wire (80) on the Pulse Crossbar (81). Connect the Upright Wire (91) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Then, remove the wire tie from the Upright Wire. Ground Wire 91 80 Console Wire 91 14.Set the console assembly on the Handrails (79). Make sure that no wires are pinched. Insert the excess Upright Wire (91) behind the Console Frame (101). Console Wire 14 79 81 Wire Tie Console Assembly 101 Attach the console assembly to the brackets on the Handrails (79) with the four 5/16" x 5/8" Screws (11) that you removed in step 10. Start all four Screws, but do not tighten them yet. 91 79 11 13 79 11