Download USER`S MANUAL

Transcript
13.With the help of a second person, hold the console assembly near the Handrails (79) (only one
is shown).
13
Console
Assembly
Connect the ground wire from the console
assembly to the Ground Wire (80) on the Pulse
Crossbar (81).
Connect the Upright Wire (91) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER. Then, remove the wire tie from
the Upright Wire.
Ground
Wire
91
80
Console
Wire
91
14.Set the console assembly on the Handrails (79).
Make sure that no wires are pinched. Insert
the excess Upright Wire (91) behind the Console
Frame (101).
Console
Wire
14
79
81
Wire
Tie
Console
Assembly
101
Attach the console assembly to the brackets
on the Handrails (79) with the four 5/16" x 5/8"
Screws (11) that you removed in step 10. Start
all four Screws, but do not tighten them yet.
91
79
11
13
79
11