Download User Manual - Rotary-engine Compression Tester System

Hardware Manager Configuration4
To begin the Hardware Manager configuration, connect the main enclosure to the computer
using the USB cable provided. Then connect the pressure transducer-quick coupler to the
enclosure and connect the power cord to the enclosure and to any 12VDC power source—usually
the car battery. If you installed the DI-145 drivers successfully, the operating system will
automatically activate the drivers for the DI-145 when the cable is plugged into the USB port.
Launch the Hardware Manager program from the Start>Programs>WinDaq® program group
menu. When the devices list appears, highlight the DI-145 device and press the Start WinDaq®
button. Continue with the following settings.
Edit>Channels
Figure 2. Hardware Manager channel selection.
4
All settings in the Hardware Manager are specific to the System hardware and are usually retained for future tests. (See note on
page 10 for more information.)
4