Download Manual - Fireplace Showcase

Stardance® Direct Vent/Natural Vent Gas Heater
Thermostat Connection (optional)
Use only a thermostat rated for 500 millivolts.
Check the table below for the appropriate gauge thermostat wire to use for the length of lead required in your installation.
Thermostat
Wire / Gauge
Maximum Run
18
20 feet
16
20 - 40 feet
14
up to 60 feet
1. Install the wall thermostat in the desired location and
run the wires to the stove location. Terminate these
leads with 1/4” female connectors.
2. Connect the thermostat wires to the valve. (Fig. 51)
Install the Front Plate
Hold the front plate by the window bars and lift it into position, engaging the two steel tabs on the top corners behind the adjacent bosses in the side plates. (Fig. 53) Then
seat the Front against the sides so the tabs at the bottom
lip engage with the notches in the stove legs.
When properly installed, the bottom of the Front Plate
cannot be pulled away from the sides without also lifting
it.
Engage steel tabs
gehind the cast
iron bosses
Receiver Installation - SDDVTCS Series
Once the blower is installed to the back of the SDDVTCS
Series stove, install the receiver.
1. Slide receiver into igniter bracket as shown in Figure
52.
2. Attach igniter bracket with receiver to valve with #1032 x 1/4 screws supplied.
3. Connect receiver wiring to valve as shown on Page
43, Figure 91.
4. Plug igniter wire from burner into the back of the igniter
bracket.
Receiver installation complete.
Control Door
Bottom tabs engage
notch in the leg.
ST474
Fig. 53 Install the front plate.
ST474 stove.
This completes assembly of the Stardance
Stardance
Front
10/3/00
Receiver
Valve
ST1121
Igniter
Bracket
Fig. 52 Install receiver.
ST1121
receiver install
30004968
29