Download LECP6 Series - SMC Pneumatics

Transcript
Stroke limit
(1-052)
B
RESET
input
<Contents> The actuator goes out the stroke limit specified
by the basic parameters, “Stroke (+)” and “Stroke (-)” if it
performs the requested operation. (Including JOG operation
after return to origin)
<Countermeasure> Make sure that the basic parameter,
“Stroke (+)” and “Stroke (-)” are consistent with the distance of
actuator movement specified in the step data.
Caution
Pushing ALM
(1-096)
ORIG ALM
(1-097)
Servo off ALM
(1-098)
Drive ALM
(1-099)
C
C
C
C
RESET
input
RESET
input
RESET
input
RESET
input
If the “Movement MOD” of the step data is relative, pay
attention to the starting point and distance of the actuator
movement.
<Contents> In the pushing operation, if push back is bigger
than pushing operation, the push back is requested.
<Countermeasure> Increase the distance from the pushing
operation origin position to the object being pushed. Or,
increase the pushing force.
<Contents> Return to origin is not completed within the set
time.
<Countermeasure> Check whether the movement of the
actuator is obstructed.
<Contents> While the servo motor is off, the return to origin
operation, positioning operation, pushing operation or JOG
operation is requested.
<Countermeasure> Modify the setting so that those
operations will be requested while the servo motor is ON (the
SVON input is ON).
<Contents> A positioning operation or pushing operation is
requested.
Before the return to origin position is completed.
<Countermeasure> Modify the setting so that those
operations will be requested after the return to origin position
is completed.
<Contents> Rreturn to origin parameter has the conditions
shown below.
Parameter setting content
ORIG mode
ORIG Sens ALM
(1-103)
C
RESET
input
1
limit switch origin [Sensor]
2
pushing origin operation [Stop]
ORIG sensor
0. Disable
or
1. N.O
or
2. N.C.
1. N.O.
or
2. N.C.
<Countermeasure> Sensor installation and return to origin
parameter and motor and sensor type is setting to have
confirm.
- 50 -