Download CH-01 UserGuide.qxd (Page 2 - 3)
Transcript
Contact Chauvet USA Tecnical Assistance: 1-800-762-1084 (954) 929-1115 E-Mail [email protected] 9 Foot Tripod Stand Caution CH-01 Always use safety pins. Never exceed the load capacity. Technical Specifications User Guide Maximum Load: 45 Kg / 100 lbs Please read these instructions carefully before use Extends: 3.7 m / 9 ft W eight: 6.6 Kg / 14.75 lbs World-wide Headquarters: 3000 North 29th Ct., Hollywood, Florida, USA, FL 33020 Tel: +1-954-929-1115 Fax: +1-954-929-5560 User Informtion (Please complete for your records) Date Purchased: Dealer Stamp: / / Serial No: ________________ Model: CH-01 9 Ft Tripod Stand www.ChauvetLighting.com Lower Lighting Bars Loosen top lighting bar knob. Snap lighting bar into upper pole extension. Upper Pole Extension Knob Using supplied mounting screws, secure lighting effects to lighting bar. Take care to balance weight evenly. Do not exceed 100 lbs. Lower Pole Extension Knob Loosen upper pole extension knob and raise pole to desired height. Stand extends a maximum of 9ft. Leg Extension Knob Installation/Mounting Top Lighting Bar Mounting Screws Lighting Bar Knob This unit has been designed to be set on a flat level surface. Failure to do so could cause serious injury. Introduction Congratulations on the purchase of your new CHAUVET lighting stand. We are confident you will enjoy many trouble free hours with this unit. To assist with the care and use of the product we have prepared this short guide. Cleaning The body of the unit should be cleaned with a soft damp cloth. Other Products from Chauvet Operation This tripod stand has been designed to hold a maximum of 100lbs. balanced evenly on the lighting bars. PAR38C Chrome Also Available in black F750 Category I Fogger Loosen leg extension knob and pull outwards on legs to widest position for optimum stability.Tighten leg extension knob. Tighten set screw with supplied allen wrench. Loosen lower pole extension knob and pull pole upwards to fully extend lower pole. Tighten pole extension knob. Tighten set screw with supplied allen wrench. Loosen lower lighting bar knobs. Slide the lighting bars onto upper pole extension and tighten. Be sure that the support bracket is fully extended. CH-219 CH-323 Obsession Zipper