Download 313.1 KB

ASAHI AV VALVES
Installation, Operation and Maintenance Manual
(14) Troubleshooting
Problem
Cause
Treatment
The valve has already been opened (closed) Turn the handle in the reverse
fully.
direction.
The handle is not (can’t be)
The valve is kept under power in the direction
Turn off the power source.
turned when the valve is
reverse to the handle operating direction.
operated manually.
Disassemble the valve to remove
Foreign matter is in the valve.
foreign matter. (Refer to page 13)
The power source of the control panel is
Turn on the power source.
turned off.
The valve does not operate by
The actuator is disconnected.
motor-driven operations
Check the connection again.
(Refer to page 7)
Open and close are power simultaneously.
Replace the diaphragm with a new
one. (Refer to page 13)
Replace scratched parts with new
Fluid leaks from the valve The diaphragm or the body is scratched.
ones. (Refer to page 13)
even when the valve is closed
There is foreign matter between the diaphragm Disassemble valve to remove foreign
fully.
and the body.
matter. (Refer to page 13)
The diaphragm is worn.
The voltage is low.
Check the voltage.
The bolt between the body and actuator is Tighten the bolt to the specified
loose.
torque. (Refer to page 13)
Replace scratched parts with new one.
The diaphragm or the body is scratched.
(Refer to page 13)
There is foreign matter between the diaphragm Disassemble valve to remove foreign
The actuator operates, but the
and the body.
matter. (Refer to page 13)
valve does not open or close.
The diaphragm or the joint metal fitting is Replace broken parts.
broken.
(Refer to page 13)
Fluid leaks from the valve.
(15)Handling of residual and waste materials
Warning
- Make sure to consult a waste treatment dealer for recommendations on the proper disposal of plastic valves.
(Poisonous gas is generated when the valve is burned improperly.)
Diaphragm Valve Type 15 Electric Actuated Type H 125, 150mm
17