Download Solution 4+4 Operators Manual

Transcript
Solution 4+4
Operators Manual
9
Basic System Operation
The overall purpose of your alarm system is to deter any would be intruder
from entering your premises.
Before leaving your home or office, make sure all windows and doors are
closed. Enter your designated
followed by the
button. Your alarm
system will now arm in AWAY Mode and commence counting down the exit
time.
After the exit time has expired, you will hear one long beep at the remote
codepad to indicate that the system has been armed in AWAY Mode. Any
unsealed zones will be automatically isolated. The control panel is now ready
to activate the sirens and strobe lights should an alarm occur.
If a zone that is sealed has triggered after exit time has expired, a number of
events will occur. Following is a typical sequence of events.
1.
The control panel will activate any audible devices such as sirens,
flashing blue strobe light and the communications dialler.
2.
The communication dialler will transmit all relevant alarm information
via the telephone line alerting the respective persons of the current state
of events.
3.
The siren timer will commence counting down as soon as an alarm
occurs. When the siren run time expires, the siren will automatically
reset and be placed into a ready state for the next alarm.
4.
Upon your return, the blue strobe light may still be operating to inform
you that there has been an alarm.
5.
One or a number of zone indicators will be flashing, allowing you to
identify the particular zone(s) that caused the alarm condition.
This is a very basic outline of the general system operation. As there are many
features available in the Solution 4+4 control panel, there could be
numerous variations from the above sequence.
Electronics Design and Manufacturing Pty Limited
Technical Manuals Online! - http://www.tech-man.com
ISSUE125.DOC