Download User Manual - Gearify Software

The number of points each primitive receives is proportional to the length of that primitive vs.
the total length of the outline curve. So if you specify 1000 sample points and 1/10th of the
length is composed of an ellipse segment, 1000/10 = 100 vertices will be used to approximate
that ellipse segment.
You can use your uploaded tooth outline in combination with any of the base curve design
methods. The currently open design tab in the Base Curve section under the Design tab will
be the base curve that is used. The tooth outline will be visible when designing your base curve,
so you can even use the Draw design mode and trace around the tooth-outline to produce your
base curve.
28