Download User`s Manual (English)

Transcript
WORKING WITH 3D FILES
MEASURING IN 3D FILES
Snapping
Mode
Entities
Vertex
Line
Arc Center
Plane
Vertex
Distance
between two
points.
The shortest
segment connecting
the point and the
line.
The shortest
segment connecting
the point and the
arc.
The shortest
segment connecting
the point and the
plane.
Distance between
two lines.
The line and axis
must be parallel.
Distance between
the line and arc axis.
The distance
between the line and
the plane.
Line
The lines must
be parallel.
NOTE:
Arc Center
Distance between
the axes of the arcs.
Arc planes
must be parallel.
NOTE:
Plane
NOTE: The line must
be parallel to the
plane.
Distance between
the arc axis and the
plane.
The plane and
the arc plane must be
perpendicular.
NOTE:
Distance between
the two planes.
The planes
must be parallel.
NOTE:
TASK
1.
From the Analysis menu, select Measure.
ADDITIONAL INFORMATION: From the AutoVue toolbar, you can also click Measure
.
STEP RESULT: The Measurement dialog appears.
2.
Click the Distance tab.
3.
Select the snapping modes that you want to use for measuring.
ADDITIONAL INFORMATION: See “3D Snapping Modes” for more information.
STEP RESULT: All entities of the selected snapping modes are highlighted on the model.
4.
From the Units list, select a measurement unit.
5.
On the model, select an entity as the starting point for the measurement.
ADDITIONAL INFORMATION: If you want to take more than one measurement from the same
starting point, select Fix Position.
150