Download Gemini Pattern Editor v.X9 - User Manual

Transcript
User manual - Gemini Pattern Editor
Plan
To distribute sizes on grading group, you must
check/uncheck the table columns that corresponds to
each size. A size cannot be allocated (checked) but to a
single grading group unless you check the option « The
sizes can be associated to more than one size ». After
you have done these operations, you must click on
« Accept » button to apply changes.
If you check the option « Measures can be common to
multiple bases » you can use a size from the set for
multiple grading bases; thus you will be able to eliminate
some patterns from the model for some specific sizes.
Regarding this, the pattern number can be different for
various sizes; this will be mentioned while importing the
model in Gemini Cut Plan application.
1.10.14 Change the grading group for a pattern
To change a grading group for a pattern, enter the « GRADING » mode, click to select the pattern, then choose the
grading group from the right side menu.
251