Download WattNode BACnet - Installation and Operation Manual

Transcript
Object #
Object Name
Units
Description
8
9
10
11
12
13
14
PowerReacA
PowerReacB
PowerReacC
PowerAppSum
PowerAppA
PowerAppB
PowerAppC
VAR
VAR
VAR
VA
VA
VA
VA
Reactive power, phase A
Reactive power, phase B
Reactive power, phase C
Apparent power, sum of active phases
Apparent power, phase A
Apparent power, phase B
Apparent power, phase C
V
V
V
V
V
V
V
V
Average line-to-neutral voltage
RMS voltage, phase A to neutral
RMS voltage, phase B to neutral
RMS voltage, phase C to neutral
Average line-to-line voltage
RMS voltage, line-to-line, phase A to B
RMS voltage, line-to-line, phase B to C
RMS voltage, line-to-line, phase A to C
Hz
Power line frequency
A
A
A
RMS current, phase A
RMS current, phase B
RMS current, phase C
Voltage Objects
15
16
17
18
19
20
21
22
VoltAvgLN
VoltA
VoltB
VoltC
VoltAvgLL
VoltAB
VoltBC
VoltAC
Frequency Object
23
Freq
Current Registers
24
25
26
CurrentA
CurrentB
CurrentC
Power Factor Registers
27
28
29
30
PowerFactorAvg
PowerFactorA
PowerFactorB
PowerFactorC
Power factor, average
Power factor, phase A
Power factor, phase B
Power factor, phase C
Demand Registers
31
32
33
34
35
36
37
DemandSum
DemandApp
DemandA
DemandB
DemandC
DemandMin*
DemandMax*
W
W
W
W
W
W
W
Real power sum demand
Apparent power sum demand
Real power demand, phase A
Real power demand, phase B
Real power demand, phase C
Minimum power sum demand
Maximum power sum demand
* These registers are preserved across power failures.
† These registers support resetting or presetting the value.
Analog Value Objects - Configuration and Diagnostics
The WattNode meter uses Analog Value objects for configuration and diagnostics. For all the
Analog Value objects the following properties are supported:
●● Present_Value (85): This reports or sets the configuration or diagnostic value as a floating
point number.
●● Object_Identifier (75): A combination of the Object_Type and Object_Number.
●● Object_Name (77): A string name for this object, such as CtAmpsA.
●● Object_Type (79): This reports ANALOG_VALUE (2) for all analog value objects.
●● Units (117): The units for this object. Many of the Analog Value objects have “No Units”.
Operating Instructions33