Download EMAX® 2 PLUS SYSTEM

Manual Cleaning
Attachments
ATTACHMENTS
Caution: Manual Cleaning Instructions for all
Attachments except the Minimal Access (MA)
Attachments and bearing sleeves.
Detergents
• Alkaline detergents with a maximum pH of 11 are
recommended for the manual washing of the attachments.
• The process, detergent and any additives must be
discussed with detergent manufacturer.
Note: “DO NOT IMMERSE” as marked on attachments is for OR personnel only.
Please refer to cleaning instructions provided with
the MA attachments for Minimal Access (MA) Attachments, Minimal Access Drivers (MA-D20, MADRIVER), Minimal Access Bearing Sleeves (MA-10S,
MA-10C, MA-15S, MA-15C, MA-15ST, & MA-19ST).
Warning: Wear eye protection and any additional
PPE required.
Caution: Do not use alkaline detergent with a pH
greater than 11. Alkaline detergents attack grease
and seals which can increase wear and cause device
malfunction. Please note use of alkaline detergents
can cause color to fade but this does not impair
function of device. Do not use ultrasonic equipment
or corrosive or harsh chemical soaps. Do not rinse
attachment with saline solution.
1
Preparation
Assemble all necessary supplies including Attachment
Cleaning Brush (ACB), sponge, lint-free cloth and soft
bristle brush. Remove the attachment and dissection
tool from the handpiece (Figure 1).
CSR60 only: The red storage cap provided with the
Perforator Driver is to prevent damage to the shaft.
The cap is removed for cleaning, washing and sterilization (Figure 2). The cap is used for storage purposes
only.
Figure 1
2
Immerse
Fully immerse the attachment in an alkaline cleaner
(non-chlorinated detergent), prepared as described on
the product label, at room temperature, in a suitable
container and agitate for 15 seconds (Figure 3).
Figure 3
33 DePuy Synthes Companies Anspach eMax 2 Plus System User’s Manual
Figure 2