Download Manual

CX70M-PE
CHAPTER 1: INTRODUCTION
1.1
BEFORE YOU START
Thank you for choosing our product. Before you start installing the
mainboard, please make sure you follow the instructions below:
„ Prepare a dry and stable working environment with
sufficient lighting.
„ Always disconnect the system from power outlet
before operation.
„ Before you take the mainboard out from anti-static
bag, ground yourself properly by touching any safely
grounded appliance, or use grounded wrist strap to
remove the static charge.
„ Avoid touching the components on mainboard or the
rear side of the board unless necessary. Hold the board
on the edge, do not try to bend or flex the board.
„ Do not leave any unfastened small parts inside the
case after installation. Loose parts will cause short
circuits which may damage the equipment.
„ Keep the system from dangerous area, such as heat
source, humid air, and water.
1.2
PACKAGE CHECKLIST
3.5” Mainboard x 1
Fully Setup Driver CD x 1
IDE Cable x 1 (Optional)
SATA Cable x 1 (Optional)
HDD Power Cable x 1 (Optional)
3