Download Protocol - Norgen Biotek Corp.
Transcript
Procedures All centrifugation steps are carried out in a benchtop microcentrifuge. Various speeds are required for different steps, so please check your microcentrifuge specifications to ensure that it is capable of the proper speeds. All centrifugation steps are performed at room temperature. The correct rpm can be calculated using the formula: RPM = RCF (1.118 x 10-5) (r) where RCF = required gravitational acceleration (relative centrifugal force in units of g); r = radius of the rotor in cm; and RPM = the number of revolutions per minute required to achieve the necessary g-force. IMPORTANT NOTE: This procedure is written in three sections. Section 1 contains the protocols to lyse various types of starting materials. Section 2 contains the protocols to isolate total RNA, genomic DNA and proteins, while Section 3 contains the protocols to separately isolate large RNA, genomic DNA, microRNA (<200 nt) and proteins. Please ensure that the proper protocol is followed for your needs. Section 1. Preparation of Lysate from Various Cell Types Notes Prior to Use for all Purification Procedures Please ensure that the correct procedure for preparing the lysate from your starting material is followed. All centrifugation steps are carried out in a benchtop microcentrifuge at 14,000 x g (~ 14,000 RPM) except where noted. All centrifugation steps are performed at room temperature. A variable speed centrifuge should be used for maximum kit performance. If a variable speed centrifuge is not available a fixed speed centrifuge can be used, however reduced yields may be observed. Ensure that all solutions are at room temperature prior to use. Prepare a working concentration of the Wash Solution A by adding 90 mL of 96-100% ethanol (provided by the user) to the supplied bottle(s) containing the concentrated Wash Solution A. This will give a final volume of 128 mL. The labels on the bottles have a box that may be checked to indicate that the ethanol has been added. Prepare a working concentration of the Wash Solution EI by adding isopropanol (provided by the user) to the supplied bottle containing the concentrated Wash Solution EI: o Cat # 24200: Add 15 mL of isopropanol for a final volume of 30 mL o Cat # 24210: Add 40 mL of isopropanol for a final volume of 80 mL The label on the bottle has a box that may be checked to indicate that the ethanol has been added. Add 93 mg of DL-Dithiothreitol (DTT, not provided) to the Protein Loading Dye. The Protein Loading Dye should be stored at -20°C after the addition of DTT. The label on the bottle has a box that may be checked to indicate that DTT has been added. Optional: The use of -mercaptoethanol in lysis is highly recommended for most tissues, particularly those known to have high RNAse content (ex: pancreas). It is also recommended for users who wish to isolate RNA for sensitive downstream applications. Add 10 L of -mercaptoethanol (provided by the user) to each 1 mL of Buffer SK 8