Download Manual - White Light
Transcript
Physical installation Read ‘Safety information’ on page 4 before installing the fixture. The fixture is designed for indoor use only and must be used in a dry location with adequate ventilation. Ensure that none of the fixture’s ventilation slots are blocked. Fasten the fixture to a secure structure or surface. Do not stand it on a surface or leave it where it can be moved or fall over. If you install the fixture in a location where it may cause injury or damage if it falls, secure it as directed in this user manual using a securely anchored safety cable that will hold the fixture if the primary fastening method fails. Martin™ can supply safety cables and rigging clamps that are suitable for use with the fixture (see ‘Accessories’ on page 47). Fastening the fixture to a flat surface To mount the fixture on a wall or other vertical surface: 1. Check that the surface can support at least 10 times the weight of all fixtures and equipment to be installed on it. 2. Obtain two 8 mm diameter hex bolts or screwbolts with max. 13 mm head size and install them 90 mm (3.5 in.) apart (center to center), in the mounting surface. 3. Install an eyebolt securely in the mounting surface to use as an anchoring point for the fixture’s safety cable. 4. Fold the fixture’s mounting bracket so that it lies flat against the back of the fixture and lock it in position by tightening the clamping handles. Lift the clamping handles away from the bracket slightly until they turn freely, then turn them so that they lie flat against the fixture and will not get in the way when you hang the fixture on the mounting surface. Alternatively, you RUSH Wizard User Manual 11