Download G1000 - Neoptix

Warning
Permanent damage may be done to the thermometer if the power supply connections are not done correctly.
In particular, do not connect the power input (18-24 VDC) to any of the analog output connectors. Note that
the 20 mA analog output options are self-powered interfaces (by opposition to loop-powered interfaces), and
thus do not require any external supply. Maximum loop impedance should be kept at 400 Ω; internal
impedance is approximately 0.7Ω.
With 0-10 volt analog outputs, avoid shorting output leads together; as this may destroy the electronic drivers
inside the unit; external impedance must be kept at all-time at 10 kΩ or more. Unit must be returned to
Neoptix for repair, not field repairable.
Fiber optic probes and extension cables are fragile, and will break if the bending radius becomes less than
~1 cm, even temporarily. Probe breakages are not covered under the standard Neoptix warranty.
To assure cleanliness of optical connectors, keep caps on unused connectors at all time. This is also required
during operation, as parasitic light entering via unused connectors into the Reflex module may cause false
temperature readings, even on other channels.
The Neoptix Reflex products are CE marking certified.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Document no. G1000r09
Copyright Neoptix Canada LP
3