Download User`s Manual

Transcript
3. Hardware Setup
3. Hardware Setup
Before setting up the hardware of the MPC-WA1HA, always make sure that the power supply is off.
Opening and closing the chassis
Opening procedure
Take the following steps to open the chassis.
1. Use the attached key to unlock the chassis (as (1) in the sketch shown below).
2.
Pull the left and right handles toward you (as (3) in the sketch) while holding down their latches ((2)
in the sketch).
(2)
(3)
(2)
(1)
Figure3.1 Unlocking the chassis
3.
Remove a pair of left and right screws ((4) in the sketch shown below).
(4)
(4)
Figure 3.2 Removing the screws
MPC-WA1HA
13