Download Manual

Operating
Transmitter and receiver must be set to the same combination of frequency group
and channel. If you use multiple wireless systems from this device family, for best
results you should assign all systems to the same frequency group, but give each
system a different channel.
Setting the frequency directly
As an alternative to selecting the frequency group and channel, you can also adjust the trans‐
mission frequency directly.
Keep [SET] pressed for some seconds until the field ‘FREQ’ is flashing in the top row of the dis‐
play. Use the [+] / [–] buttons to increase or decrease the displayed value. When the desired
value is shown, press [SET] to confirm the setting and to quit the menu.
In the bottom right area, the display shows the adjusted transmission frequency in MHz.
Selecting the operating mode
Keep [SET] pressed for some seconds until the field ‘FREQ’ is flashing in the top row of the dis‐
play. Press [SET] again until the field ‘MODE’ is flashing in the top row of the display.
Use the [+] / [–] buttons to toggle between mono and stereo operation. When the desired
mode is shown, press [SET] to confirm the setting and to quit the menu.
UHF wireless system
40