Download Digger-Inverters - Amadas Industries

AMADAS Digger-Inverters
Setup
Setup Instructions
Fenders and Vine Deflector
Shields
2. Remove the vine deflector shield.
The digger-inverter is shipped with its fenders
and vine deflector shields in the stored
position.
3. Insert the top tab of the shield through the
slot in the conveyor side frame as shown
below.
Tab on top of shield
Slot in machine side
NOTE! The machines shown in photos
may vary slightly from your machine, as
different models are available. Unless
otherwise noted, instructions are the same
for all models.
Vine Deflector Shields
In order to install the vine deflector shields,
remove fenders from stored position.
4. Position the vine deflector shield as shown.
Install
additional
bolt here
Vine
deflector
shield
To position the vine deflector shields:
1. Remove the bolts indicated in the photo.
Remove
these
bolts
5. It may be necessary to rotate inverter rotor
to get deflector in proper position.
6. Install and tighten all of the bolts. Note that
there is an additional bolt in the middle of
the panel as shown in the photo.
Vine
deflector
shield
MAN138
7. Install fenders and adjust position as
needed.
Slot
3/2/15
17