Download Replacement Part List

TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Then handle is not
in position.
The carriage bolts are not
properly seated.
Adjust the height of the handle, and verify
that the carriage bolts are properly seated.
Tighten the knobs.
The Snow Thrower
does not start.
The power cord is disconnected Reconnect the cord, and use the cord
from the switch.
restraint to keep the cord close to the
switch.
The switch is defective.
Replace the switch.
The extension cord is not
connected to the plug.
Connect the plug on the Snow Thrower to
the extension cord.
The extension cord is not
Plug the extension cord into a live 120 V
connected to the power source. AC, 60 Hz outlet.
The motor is on, but The belt is damaged.
the rotor does not
turn.
Replace the belt (see the section entitled
Inspecting/Replacing the Drive Belt).
The Snow Thrower The scraper is worn.
leaves a thin layer of
snow behind.
Replace the scraper (see the section
entitled Replacing the Scraper).
21