Download USER MANUAL - MARUSON Technology

1. Important Safety Warning
6. Specifications
MODEL
CAPACITY*
INPUT
Low Line Transfer
Voltage
Range
Low Line Comeback
High Line Transfer
High Line Comeback
Frequency Range
Phase
Power Factor
OUTPUT
Output voltage
AC Voltage Regulation
Frequency Range
(Synchronized Range)
ULT-1K(L)
1000 VA / 800 W
ULT-2K(L)
2000 VA / 1600 W
160VAC/140VAC/120VAC/110VAC ± 5% or 80VAC/70VAC/60VAC/50 VAC ± 5%
( based on load percentage 100% - 80 % / 80 % - 70 % / 70 - 60 % / 60 % - 0)
168VAC/148VAC/128VAC/118VAC ± 5 % or 84VAC/74VAC/64VAC/54 VAC ± 5 %
( based on load percentage 100% - 80 % / 80 % - 70 % / 70 - 60 % / 60 % - 0)
300 VAC ± 5 % or 150 VAC ± 5 %
290 VAC ± 5 % or 145 VAC ± 5 %
40 ~ 70 Hz (Auto sensing)
Single phase with ground
0.98
208/220/230/240VAC or 110/115/120/127VAC
± 1%
47 ~ 53 Hz or 57 ~ 63 Hz
Frequency Range (Batt. Mode)
50 Hz ± 0.25 Hz or 60Hz ± 0.3 Hz
Current Crest Ratio
Harmonic Distortion
Transfer AC Mode to Batt. Mode
Time
Inverter to Bypass
Waveform (Batt. Mode)
EFFICIENCY
AC Mode
Battery Mode
BATTERY
Battery Type
Battery Numbers
Standard
Charging Current
Model
(max.)
Charging Voltage
Battery Type &
Long
Numbers
Runtime
Charging Current
Model
Charging Voltage
PHYSICAL
Dimensions
Standard
(DxWxH)(mm)
Model
Net Weight (kgs)
Long
Dimensions
Runtime (DxWxH)(mm)
Model
Net Weight (kgs)
ENVIRONMENT
Operation Humidity
Noise Level
MANAGEMENT
Smart RS-232 Port/Card
Intelligent Slot
ULT-3K(L)
3000 VA / 2400 W
4 % THD (Linear Load)
7 % THD (Non-linear Load)
Zero
4 ms (Typical)
Pure Sinewave
88.5 % (89% peak)
83.7 % (86% peak)
1-1. Transportation
l
Please transport the UPS system only in the original packaging to protect against
shock and impact.
1-2. Preparation
l
Condensation may occur if the UPS system is moved directly from cold to warm
environment. The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate to the environment.
l
Do not install the UPS system near water or in moist environments.
l
Do not install the UPS system where it would be exposed to direct sunlight or near a
heater.
l
Do not block ventilation holes in the UPS housing.
1-3. Installation
3:1
3 % THD (Linear Load)
6 % THD (Non-linear Load)
Please comply with all warnings and operating instructions in this manual strictly. Save this
manual properly and carefully read the following instructions before installing the unit. Do not
operate this unit before reading through all safety information and operating instructions
carefully.
89.3 % (90% peak)
88.2 % (89% peak)
To guarantee UPS normal operation, before connecting devices to the UPS, please
verify that ground and neutral lines of the connected devices are not short circuited.
(see Figure 1)
87%
85%
12V / 9Ah
2
4
6
54.7 VDC ± 1%
82.1 VDC ± 1%
1.0 A
27.4 VDC ± 1%
Figure 1
Depending on the capacity of external batteries
1A / 2A / 5 A (Default)
27.4 VDC ± 1%
1A / 2A / 4A / 8A (Default)
54.7 VDC ± 1%
82.1 VDC ± 1%
400 X 146 X 205
397 x 145 x 220
9.3
17.8
28.8
400 X 146 X 205
397 x 145 x 220
421 x 190 x 318
4.8
7.4
13.5
If neutral line and ground line are short circuited, please add isolation transformer
between UPS and devices. (see Figure 2)
421 x 190 x 318
20-90 % RH @ 0- 40°C (non-condensing)
Less than 45dBA @ 1 Meter
Figure 2
Supports Windows® 2000/2003/XP/Vista/2008, Windows® 7, Linux, Unix, and
MAC
Power management from SNMP manager and web browser
* Derate capacity to 80% when the output voltage is adjusted to 208VAC.
Maruson Technology Corporation
17
ULTIMA SERIES 1K-3KVA | 2012 Jan.
Maruson Technology Corporation
2
ULTIMA SERIES 1K-3KVA | 2012 Jan.