Download to select - Studio 22

Error messages (examples)
Error Messages
Measures
NOTE
n When Performing Audyssey Auto Setup Over
Again
n When Measuring has Stopped
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• Connect the included setup microphone to the
SETUP MIC jack of the AVR-4810CI.
• Check the speaker connections.
Multi-zone
ress RETURN, the “Cancel auto setup?” prompt is displayed.
P
Press o p and select “Yes”, then press ENTER.
Playback
Press ui to select “Retry”, and then press ENTER.
• Included setup microphone is not connected.
Settings
Be sure to turn off the power before checking speaker connections.
Connections
An error message is displayed if it was not possible to complete
Audyssey Auto Setup due to speaker placement, the measurement
environment, etc. If this happens, check the relevant items, be sure
to take the necessary measures, then perform Audyssey Auto Setup
over again.
Error contents
• Correct measurement is not possible due to • When using a subwoofer with built-in amplifier
inappropriate subwoofer volume.
(active type), use “SW Level Matching” to adjust
the subwoofer volume (vpage 38).
• When using a subwoofer without a built-in
amplifier, select “Skip”, and then press ENTER.
Getting Started
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
• Displayed speaker could not be detected.
• Check the connections of the displayed speaker.
Remote Control Information
• Too much noise in the room for accurate • Either turn off any device generating noise or
measurements to be made.
move it away.
• Perform again when the surroundings are
quieter.
• Speaker or subwoofer sound is too low for • Check the speaker installation and the direction in
accurate measurements to be made.
which the speakers are facing.
• Adjust the subwoofer’s volume.
Troubleshooting
Main remote control unit
operation buttons
1.AVR4810CIEU_007.indd
41
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting
:Return to previous menu
Specifications
• Displayed speaker connected with the polarities • Check the polarities of the displayed speaker.
reversed.
• For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure the connection is
correct, press ui to select “Skip”, then press
ENTER.
37
2009/08/04
12:07:44