Download RELAP5 Plug-in Users Manual

Table of Contents
1. Introduction .........................................................................................................
2. Creating a RELAP5 Model ..................................................................................
2.1. Importing an Existing ASCII File ...............................................................
2.2. Creating a New RELAP5 Model ................................................................
2.3. Opening an Existing RELAP5 Model .........................................................
2.4. RELAP5 Model Editing ............................................................................
3. Editing A Model ..................................................................................................
3.1. Model Properties .......................................................................................
3.2. Hydraulic Components ..............................................................................
3.2.1. Single Volume ...............................................................................
3.2.2. Time Dependent Volume ................................................................
3.2.3. Single Junction ...............................................................................
3.2.4. Time Dependent Junction ................................................................
3.2.5. Pipe ...............................................................................................
3.2.6. Annulus .........................................................................................
3.2.7. Pressurizer .....................................................................................
3.2.8. CANDU Channel ...........................................................................
3.2.9. Branch ...........................................................................................
3.2.10. Separator ......................................................................................
3.2.11. Jet Mixer ......................................................................................
3.2.12. Turbine ........................................................................................
3.2.13. ECC Mixer ...................................................................................
3.2.14. Valve ...........................................................................................
3.2.15. Pump ...........................................................................................
3.2.16. Compressor ..................................................................................
3.2.17. Multiple Junction ..........................................................................
3.2.18. Accumulator .................................................................................
3.2.19. Multi-Dimensional Component ......................................................
3.2.20. Feedwater Heater ..........................................................................
3.3. Control Systems ........................................................................................
3.3.1. Signal Variables .............................................................................
3.3.2. Control Blocks ...............................................................................
3.3.3. Trips ..............................................................................................
3.3.4. General Tables ...............................................................................
3.3.5. Interactive Variables .......................................................................
3.4. Heat Structures .........................................................................................
3.5. Radiation Enclosure ..................................................................................
3.6. Materials ...................................................................................................
3.7. Reactor Kinetics ........................................................................................
4. Editing a Restart Case ..........................................................................................
5. ASCII I/O ...........................................................................................................
5.1. Input Decks ..............................................................................................
5.2. Restart Decks ............................................................................................
6. Model Validation Tests ........................................................................................
7. 3D Visualization ..................................................................................................
7.1. 3D Coordinate Generation .........................................................................
7.2. 3D Model Viewer .....................................................................................
7.2.1. Camera Controls .............................................................................
iii
1
3
3
5
6
6
9
9
11
11
12
13
13
14
23
23
24
25
26
27
28
29
30
30
30
31
34
35
41
41
41
42
43
43
44
45
49
50
51
61
63
63
63
65
67
67
67
68
RELAP5 Plug-in User's Manual