Download User Manual - Transgenomic

Transcript
HANABI-PV
3.4. Selecting a Pre-set Run Protocol
This screen is used to access (or create) saved protocols. Saved protocols retain
system settings for reading code, sample dropping parameters, run conditions
and working speeds.
[Function No.]: Select protocol number.
<READ> key: Protocol setting values are read based for the selected Function Number.
<SAVE> key: Current settings, such as sample operation conditions and working speed
are saved into the selected function number.
<ALL RESET> key: Sample settings and operating conditions of the selected Function
No. are reset to system default values based on the settings in
“3.10. Dropping setting”.
[reading CODE]: Default is set to use Bar code ID Read function for sample tubes and
glass slides.
This “sample (bar)Code ID Reading” can be switched “ON” or “OFF”
by pressing “Num Input” key when cursor is blinking over the ON
section.
Caution
In case of existing same ID tubes in sample tip holder, front side tube
(tube read ID by tube reader in first) is given preference for dropping
sample. Please be careful that posterior tube wasn’t executed dropping
sample at that time.
<Sample Setting> key: The screen is switched to “3.5. Sample 1,2 setting”.
<Operation Condition> key: The screen is switched to “3.10. Dry-Index setting”.
<↑> key: Move a cursor to upward
<↓> key: Move a cursor to downward
<Num Input> key: This key is used for alteration of the value which is on the cursor.
The screen is switched to “3.18. Numeric keypad”.
<TOP> key: The screen is switched to “3.2. MAIN”.
14
Transgenomic / ADSTEC Corporation