Download EHEV3-USBUV

Transcript
103 mils/2.6 mm. See Fig. 8a.
Fig. 8a – Test specimen dimension.
Fig. 8b – Low specimen magnification.
Fig. 8c –Ex Hi specimen magnification.
Viewing Fig. 8b and 8c at 2x using Paint Shop Pro on my 37.5 cm wide LCD monitor I measured the
outside edges of “i” and “n” as shown in fig. 8a as follows: Fig. 8b = 100.42 mm. Fig. 8c = 224.46 mm.
Under these conditions the ratio is 224.46/100.42 = 2.2. The respective “magnifications” of the images as
seen on my screen are: Fig. 8b = 38.6x and Fig. 8c = 86x. It is more reasonable (accurate) to use the 1x
numbers or half of these for the “true” magnification. Fig. 8b = 19.3x and Fig. 8c = 43x. Of course this is
only based on the screen size (See article titled Microscope Magnification).
The “revised” focus range numbers are 0.40” for the 3/8” stage, 0.27” for the base thickness, and 0.22”
for the highest useable spacers (see Fig. 5) = 0.89” or 22.6 mm. That is about 7/8ths of an inch. Keep in
mind that these numbers are for a product sampling of one and that other products will vary slightly.
From a practical perspective you want the adjustment ring to be able to go slightly past the focus and you
“back up” to confirm the best focus.
Magnification
Basically the uv microscope as used in the stand and on a wood base (Fig. 7) has four magnifications.
EH: The highest magnification is the closest position to the camera. This would be on the 3/8” stage and
this is a limit to the physical size that may be viewed. The specimen may not extend outside the 3/8”
circle. This is suitable for small electrical parts, ants, small bugs & beetles, and specimens that may be
cut to fit on the 3/8” diameter stage. I call this extra high, EH, magnification.
HI: The microscope may be used without the stand (handheld) for normal magnification. There is no
limit on the specimen size. I call this high, HI, magnification.
MD: The next magnification is on the 3/4" stage and this also places a limit to the specimen size that may
be viewed. The same limitations for extra high magnification (in the stand) also apply except that the
physical size limit is twice that of extra high magnification. I call this medium, MD, magnification.
LO: The lowest magnification is that obtained with the subject furthest from the camera and still be in
focus. This is when the microscope is raised up on a spacer of 0.22” as shown in Fig. 5 or held up with
the added thumb screw. I will call this low, LO, magnification.
As I mentioned above the range of the low to high magnification is about 2.2:1
Page 5 of 11