Download User Manual - High End Systems

Transcript
fixture head
tilt screws (4)
lamp
lamp cap
lamp cap
screws (4)
lamp socket wires
Figure A-1. Removing the lamp cap
4.
Using a 5/32” allen wrench, remove the four lamp cap screws (see
Figure A-1).
5.
Pull the lamp cap and attached lamp straight out of the fixture.
6.
The lamp cap is connected to the fixture by lamp socket wires (see
Figure A-1). Support the lamp cap while replacing the lamp. Do not
allow the lamp socket wires to support the weight of the lamp cap.
7.
Hold the existing lamp by its
ceramic base and carefully pull the
lamp up and out of the lamp socket
(see Figure A-2).
Caution: do not squeeze the lamp glass
when removing or installing
the lamp. Lamp glass may
shatter.
8.
Holding the new lamp by its
ceramic base, align the base pins
to the socket (see Figure A-2) and
carefully press the lamp into the
socket until the lamp is firmly
seated.
lamp glass
ceramic base
base pins
O-ring
lamp socket
lamp cap
Figure A-2. Installing the lamp
Warning: do not touch the lamp glass with bare fingers. The oils from your
skin can damage the lamp and cause it to explode. If the lamp is
A-8
ES-1 User Manual