Download ELAN-104 - Electrocomponents

Transcript
2192-09102-000-000
J583 ELAN-104
Using the ELAN-104
Overview
The ELAN-104 is a PC compatible processor board. There are connections on the ELAN-104 for a keyboard,
mouse, floppy drive, a hard drive, and it features three serial ports and a centronics parallel port. Additional
PC/104 modules can be connected to the ELAN-104 via the 16-bit PC/104 connector to form a configured
Industrial PC system. Various displays and keypads can be connected to the ELAN-104 using the VGA/CRT
16-way, VGA/LCD 40-way interface, Mono LCD and Matrix Keypad 40-way interface.
Block Diagram
PC/104 Interface
CRT
Header
AMD Elan SC400
Header
RS485
Driver
UART
16550
Header
Speaker
Port
User Link
GPIO
Signals
ISA Bus
Controller
ROM
Flash ROM
(x8)
2/4 Mb
Header
Graphics
LCD
Graphics
Controller
Battery
Power
Sense
Power
Management
Unitr
RTC
Back-up
Battery
Flat Panel
Header
FDD
Header
HDD
Header
SMCS FDC37932
Super I/O Controller
Matrix
Keyboard
Controller.
Matrix
Keypad
S-VGA
Controller
Flash ROM
(x8)
2/4 Mb
Memory
Controller
DRAM
DRAM
DRAM
(x16)
(x16)
2/8 Mb
2/8 Mb
COM1
RS232
Driver
DB9
Connector
COM2
RS232
Driver
DB9
Connector
Keyboard
PS/2
Connector
Mouse
PS/2
Connector
RTC
BIOS
EPROM
128kb
SRAM
Parallel
Port
Header
WDT
The ELAN-104 is based around the AMD SC400 Microcontroller. This part provides the PC-AT architecture
of the board. Most of the peripheral interfaces are provided by the AMD SC400 or the SMSC FDC37C932
Super I/O
The ELAN-104 board is designed for diskless operation and is supplied with Arcom Flash Filing System
(AFFS) and ROM-DOS 6.22 pre-loaded. AFFS allows the Flash memory on the ELAN-104 to be accessed as a
normal drive. ROM-DOS is a flexible, small and fast compatible DOS. A full ROM-DOS users manual is
supplied on the accompanying CD-ROM. More information on ROM-DOS can be found on the Datalight
website (www.Datalight.com).
Using AFFS the on-board Flash memory appears exactly as a normal hard drive interface. All application
software can be loaded onto the Flash and run exactly as if were a standard hard drive. There is no need to
configure the on-board Flash memory in the BIOS set-up utility as AFFS will automatically configure the
Flash as the C:\ drive unless a hard drive is connected in which case the AFFS drive will be moved up to the
next available drive letter.
AFFS operated using a BIOS extension to create a Flash drive at boot time. The Flash drive is fully bootable.
NOTE: Any additional drives connected to the IDE connector will be allocated as the C:\ drive. When adding
a hard drive to the ELAN-104 the hard drive should be configured as the C:\ drive in the BIOS set-up. The
AFFS will then reallocate Flash drive as the D:\ drive or the next available drive letter.
9