Download User`s Guide for SNOPT Version 7.4 - CCoM

Transcript
106
9.3.
SNOPT 7.4 User’s Guide
Dump and Load files
These files are similar to Punch and Insert files, but they record solution information in a
manner that is more direct and more easily modified. In particular, no distinction is made
between columns and slacks. Apart from the first and last line, each entry has the form
Columns
2–3
5–12
25–36
Contents
Key
Name
Value
as illustrated in Figure 4. The keys LL, UL, BS and SB mean Lower Limit, Upper Limit,
Basic, and Superbasic respectively.
Notes on Dump data
1. A line is output for every variable: columns followed by slacks.
2. Nonbasic free variables (strictly between their bounds) are output with key LL.
Notes on Load data
1. Before a Load file is read, all columns and slacks are made nonbasic at their smallest
bound in absolute magnitude. The basis is initially empty.
2. BS causes Name to become basic.
3. SB causes Name to become superbasic at the specified Value.
4. LL or UL cause Name to be nonbasic at the specified Value.
5. An entry will be ignored if Name is already basic or superbasic. (Thus, only the first
BS or SB line takes effect for any given Name.)
6. An SB line will not alter the status of Name if the Superbasics limit has been
reached, but the associated Value will is retained.
7. (Partial basis) Let m be the number of rows in the problem. If fewer than m variables
are specified to be basic, the first basis factorization will detect singularity and insert
appropriate slacks.
8. (Too many basics or superbasics) If more than m variables are specified basic, or more
than Superbasics limit are specified superbasic, the excess will be made nonbasic
before iterations begin.
9.4.
Restarting modified problems
Sections 9.1–9.3 document three distinct starting methods (Old basis, Insert and Load files),
which may be preferable to any of the cold start (CRASH) options. The best choice depends
on the extent to which a problem has been modified, and whether it is more convenient to
specify variables by number or by name. The following notes offer some rules of thumb.
Protection
In general there is no danger of specifying infinite values. For example, if a variable is
specified to be nonbasic at an upper bound that happens to be +∞, it will be made nonbasic
at its lower bound. Conversely if its lower bound is −∞. If the variable is free (both bounds
infinite), it will be made nonbasic at value zero. No warning message will be issued.