Download ZAPI AC3-AC4 Manual

2) Connection of encoder with differential outputs; +5 V power supply (Minifit
connectors).
3) Connection of encoder with open collector output; +5 V power supply (Minifit
connectors).
4) Connection of encoder with open collector output: +12 V power supply (Minifit
connectors).
U
VERY IMPORTANT
It is necessary to specify to Zapi, when ordering the controller, the type of
encoder used: power supply, electronic output and n° of pulses for
revolution. This is necessary because the logic unit must be set in the
correct way by Zapi.
4.2.6 Main contactor and key connection
-
The connection of the main contactor can be carried out following the
drawing in the figure.
ADWZP0DF - AC3 FLASH / AC4 FLASH INVERTER - User Manual
Page - 17/89