Download cerber C612 - user guide

• Phone line tone detection upon automatic initiating voice message reporting;
• Using the MPV-16/DTMF voice module, up to 16 different voice messages, as for voice zone
descriptors (12 messages) and 4 system (partitions) and customer recorded ones can be
reported upon remote interrogation calls or to the “follow-me” phone numbers;
• In case of no MPV16/DTMF module, the panel will report upon remote interrogation calls or to
the “follow-me” phone numbers synthesis sounds;
• Up to 4 “follow-me” phone numbers (for automatic control panel report on the telephone line of
the “alarm” and “AC power loss” events, by specific voice messages or by specific synthesis sounds);
RF remote control and/or proximity card operating (using Keyfob Module -01)
• Each user code can have one RF remote control transmitter (3 button keyfob – TX434)
and/or one proximity card assigned;
• The keyfob can be used as a virtual keypad (transmitting commands, no confirmation on keyfob, just
audi confirmation on keypads buzzer and keyfob module buzzer, or on system sounders, by “ding”
options programmed or visual confirmation using the keyfob module LAMP output) for
arming/disarming the user code assigned partitions, tot control PGM1 to PGM4, and for panic alarm
(for more details see “Keyfob Module 01 – Installation and Operating instructions”);
• All the user code rights are transfered to the keyfob functions too;
• Easy enrollment of the keyfob and/or proximity card, in the time of entering or modifying user code
procedure, performed by master user
• User number of the appropriate associated keyfob or card that was used, is stored in control
panel event log and reported to the Central Station, having a precise information about the user
that operated the system by the use of RF remote control os proximity card.
Miscellaneous
• Real clock timer which will stamp the 800 events stored in the control panel event LOG memory;
• “Quick arming” options: “away quick arming”, “quick stay arming” and “quick instant stay arming”
– allowed by programming;
• Options of arming by users: “away arming”, “stay arming” and “instant stay arming” – allowed by
user rights;
• Autoarming options: “timed autoarming” and “inactivity autoarming” – allowed by programming;
• Option: the system (or each partition independently) automatically switches to stay arming
mode after any regular arming (by user, by PC or by keyswitch), if the user doesn’t leave the
protected area through any entry/exit point during the exit delay;
• Option: no beeps/dings during the exit delay of stay arming modes;
• Option: Autoarming programmable in regular or home mode;
• Option: dings (audible sounds on the siren) on keyswitch arming/disarming, arming/disarming other than keyswitch and during exit delay or for 3 minutes from the moment of initiating the
autoarming;
• Option: programmable period and pause for ding sounds;
• Audible warnings for 3 minutes on generation of timed autoarming: 3 minutes from the timed
autoarming moment, on the keypad buzzer and ding sounds optionally.
• Keyswitch arming/disarming or keyswitch “stay arming”/”disarming”, as an option;
• Programmable protection against undesired resets to default values;
• Chime feature activated/deactivated by the users;
• Fuseless design (PCB - hardware system designed with electronic fuse control, to work without
fusible resistors);
• Switching power supply
• Current limitation for backup battery charging (200mA).
7