Download Installation Manual

Technical Parameter
Working principle
Xenon lamp replaces the filament of the light bulb with xenon gas by
utilizing the gas discharge principle, an arc of light is created between
two electrodes in a small capsule filled with a mixture of xenon gas and
halide salts. When high voltage is applied, the gas is ignited to produce an
arc of light. HID does not have filaments like standard halogen bulbs.
Instead an arc of electricity ignites magnetic salts within the bulb to
cause the glow. Due to this technology, HID bulbs last 10 times as long
as halogen, there is no filament to break or burn out. HID also consumes less
electricity than halogen. Halogen bulbs consume approximately 55 watts of
electricity where HID only consumes about 35 watts.
Xenon HID outputs three times the amount of light compared to a standard
halogen bulb. The lamp glows at a higher light temperature and gives it
its distinct color and appearance.
Basic Fittings
This package includes the parts as the following:
1. Automobile: 2pcs ballasts, 2pcs HID xenon lamps, 1pcs bunches of
wires, 1pc warranty card, 2pcs tape, 2pcs brackets 7pcs accessories.
2. Motorcycle: 1pc ballast, 1pc HID xenon lamp, 1 bunch of wire, 1 warranty
card, 1pc tape, 7pcs accessories.
Wires
Tape
01
www.yitoa.com/hid
Bracket
1.Open the car bonnet, check the assembly space. If the space is enough,
assemble the lamp directly. If the space is not enough, then remove the
left & right halogen headlamps from the car, then assembly.
2.Drill a hole in the middle of the rear cover with a 21mm hole cutter.
Xenon lamp
Ballasts
Installation Process
Accessories
02
www.yitoa.com/hid