Download Emulex Drivers for Solaris User Manual

Solaris emlxs and Solaris LPFC Driver Properties Cross-Reference Table
The cross-reference information listed in Table 3 refers to the driver for Solaris LPFC version 6.30.
Table 3: Solaris emlxs and Solaris LPFC Driver Property Cross-Reference
Solaris
emlxs/
HBAnyware
Property
Solaris emlxs/HBAnyware
Min/Max, Defaults and
Description
Related
LPFC
Property
ack0
0 = The driver will use ACK1
for class 2
acknowledgement.
1 = The driver will use ACK0
for class 2
acknowledgement.
Range: Min:0 Max:1
Default:0
Description: Determines if
ACK0 is used instead of
ACK1 for class 2
acknowledgement.
ack0
0 = The driver will use ACK1
for class 2
acknowledgement.
1 = The driver will use ACK0
for class 2
acknowledgement.
Range: Min:0 Max:1
Default:0
Description: Determines if
ACK0 is used instead of
ACK1 for class 2
acknowledgement.
adiscsupport
0 = No support. Flush active
I/O's for all FCP target
devices at link down.
1 = Partial support. Flush
I/O's for non-FCP2 target
devices at link down.
2 = Full support. Hold active
I/O's for all devices at link
down.
Default: 1
Description: Sets the level of
driver support for the FC
ADISC login I/O recovery
method.
use-adisc
0 = Off
1 = On
Default: 0
Description: Controls the
ELS command used for
address authentication
during rediscovery upon linkup. The driver will always
use ADISC for FCP-2
devices and re-discovery
due to an registered state
change notification (RSCN).
assign-alpa
Min:0x00
Max:0xef
Default:0x00 (valid ALPA's
only)
Description: This is only
valid if topology is loop. A
zero setting means no
preference. If multiple
adapter instances on the
same host are on the same
loop, you should set this
value differently for each
adapter.
assign-alpa
Description:Sets a preferred
ALPA for the adapter. This
parameter is only valid if the
topology is loop.
Emulex Drivers for Solaris User Manual
LPFC Min/Max, Default and
Description
Comments
If there are tape
devices on the
SAN that support
FCP2, set the
use-adisc
property to 1
and the adiscsupport property
to 1 (partial
support) or 2 (full
support).
Page 28