Download 7. Using ABC-LUFP Configurator

Transcript
10. Appendix C: Standard Configuration
The configuration described below is the standard configuration used when implementing the LUFP1 gateway.
This chapter mainly gives the user information about the performances obtained on the
downstream Modbus network. It allows users to decide whether, for example, they should
change the timing of periodic exchanges with one or more of the TeSys U motor starters (see
Chapter 7 Using ABC-LUFP Configurator, page 61).
10.1. Configuring Modbus Exchanges
The LUFP1 gateway carries out four types of exchanges with each of the 8 TeSys U motor starters. The first two
exchanges are periodic and allow you to control and monitor the motor starter. The last two exchanges are aperiodic
(triggered by a change in the values of the data to be transmitted to the motor starter) and allow you to read and
change the value of any motor starter parameter.
Function
16#03
16#10
Modbus function
Read Holding
Register
Preset Multiple
Registers
Number
of bytes (1)
11.5 + 10.5
14.5 + 11.5
(16#03)
(Read Holding
Register)
011.5 + 10.5
(16#06)
(Preset Single
Register)
11.5 + 11.5
Exchange between the LUFP1 gateway
and the TeSys U motor starter
Periodic reading (300 ms period) of the TeSys U motor
starter’s status register (address 455 = 16#01C7) only
Periodic writing (300 ms period) of the TeSys U motor
starter’s status register (address 704 = 16#02C0) only
Aperiodic reading of the value of a single parameter, for a
single TeSys U motor starter at a time (function and
address defined by the user)
Aperiodic writing of the value of a single parameter, for a
single TeSys U motor starter at a time (function and
address and value defined by the user)
(1) Number of bytes in the Query + number of bytes in the Response, plus a silence time of 3.5 characters for each of
these two frames (see description of the “Message delimiter (10ms)” parameter in Section 7.12.3 “Sub-Network”
Element, page 93). Each byte will be transmitted in the form of a group of 10 bits (8 data bits, 1 start bit and 1 stop
bit). These values allow you to calculate the approximate amount of traffic on the downstream Modbus network as
follows:
Volume of periodic traffic (300 ms period) ..................... [ (11.5 + 10.5) + (14.5 + 11.5) ] * (8 + 1 + 1) = 480 bits
For 1 TeSys U motor starter ................................................................ 1 * 480 * (1 000 ÷ 300) = 01,600 bits/s
For 8 TeSys U motor starters............................................................... 8 * 480 * (1 000 ÷ 300) = 12,800 bits/s
As a result, on a network operating at 9,600 bits/s, you will need to considerably increase the cycle time for all or some
of the periodic Modbus commands. On the other hand, at a speed of 19,200 bits/s (the default speed), the available
bandwidth is sufficient to support acceptable communications, even with the occasional degraded mode
(retransmission of frames), and to allow the use of aperiodic parameter exchanges.
111