Download Owner`s Manual

Operating Your Spa
14
Cover Latches
When your hot tub is not in use, make sure you
place the cover on top and latch it securely.
Besides protecting your hot tub from sun damage
and keeping out contaminants, it will prevent
small children from drowning in the hot tub.
Your cover will have four clips attached to the ends of
the four latches, two on each end of the hot tub cover.
There will also be a small bag with eight wood screws.
After you place the cover on the hot tub, attach the clips
to the side of the hot tub using the wood screws.
Optional Cover Lift Installation
The optional cover lift attaches to the back of the hot tub
cabinet, either on the back wall of the cabinet or on the
pedestal base.
The bridge arm lies across the hot tub parallel to the seam of
the cover. After you fold back the cover, lift up on the side arm
and the cover lift will lift the cover off the hot tub and hold it
in an upright position behind the hot tub.
You will need a Phillips screwdriver and a tape measure for
installation.
1. Step One
Position your hot tub cover (in the closed position) on
the hot tub, making sure all four corners are lined up
with the corners on the hot tub.
2. Step #2
Slide the Under-Mount Base Brackets under the hot
tub. (See Fig. 1)
Note: Be sure to use the Pivot Hole closest to the back
of the hot tub.
American Spa Owner’s Manual
LTR50001106, Rev. C