1
Download 500 Series Console (Discontinued) - Operation
Transcript
Console Setup Networker software. Although newer consoles come with the network adapter installed, older consoles need to have one installed to take advantage of ShowNet features. For more information refer to Networker The following fields are described in this section: ■ Networker On/Off ■ Networker Video Slot ■ NET 1 - NET 4 Networker On/Off Controls whether the Networker software features are enabled. This is only used when the Networker software is loaded. For more information refer to Networker Its value is OFF (default) or ON. Note: Do not turn this on without first consulting the Networker. Turning on an improperly connected system may significantly slow console operations. Network Video Slot Controls whether the network video slot is enabled, and its slot number (from 1 to 8). This is only used when the Networker software is loaded. For more information refer to Networker Its value is OFF (default) or ON. Note: Do not turn this on without first consulting the Networker. Turning on an improperly connected system may significantly slow console operations. NET1 through NET4 This configures the network DMX outputs. Since the console has only 4 active DMX connectors but up to 4096 outputs, the most common use of these is to use the network for the additional outputs. NET1 through NET4 (default is DMX|OUT for NET1 and OFF for the rest). Start and End (default is 1, 512 / 513, 1024 / 1025, 1536). The range of output numbers from the Patch that is mapped to the connector from 1 to 4096. The maximum between each Start and End is 512 outputs. Communications Window The Communications window is in the Console Setup display, and lets you configure the external communications ports. file:///C|/LIGHTP/HELP.ENG/page31.htm (4 of 7)11/2/2004 3:02:27 AM
