1
Download Ver. 2.64 User`s Manual
Transcript
4.6 [ S u r f a c e ] section 83 4.6.3 Macro body Table 4.48: macro body card symbol type BOX optional BOX (all angles are 90◦ ) RPP rectangular solid (each surface is vertical with xyz) SPH sphere (same with general sphere S) RCC cylinder RHP or HEX optional hexangular prism prism REC right elliptical cylinder TRC truncated right-angle cone ELL ellipsoid WED wedge numerical input V x Vy Vz A1x A1y A1z A2x A2y A2z A3x A3y A3z Xmin Xmax Ymin Ymax Zmin Zmax V x Vy Vz R V x Vy Vz H x Hy Hz R v1 v2 v3 h1 h2 h3 r1 r2 r3 s1 s2 s3 t1 t2 t3 V x Vy Vz H x Hy Hz V1x V1y V1z V2x V2y V2z V x Vy Vz H x Hy Hz R1 R2 If Rm > 0, V1x V1y V1z V2x V2y V2z Rm If Rm < 0, V1x V1y V1z V2x V2y V2z Rm V x Vy Vz V1x V1y V1z V2x V2y V2z V3x V3y V3z explanation base point coordinate vector from base point to first surface vector from base point to first surface vector from base point to third surface minimum x and maximum x minimum y and maximum y minimum z and maximum z center coordinate radius center coordinate of bottom face vector from V x Vy Vz to center coordinate of top face radius base point coordinate height vector from base point vector from base point to first surface vector from base point to second surface vector from base point to third surface center coordinate of bottom face vector from V x Vy Vz to center coordinate of top face ⃗ major axis vector of ellipse orthogonal to H ⃗ and V ⃗1 minor axis vector of ellipse orthogonal to H center coordinate of bottom face of cone height vector from V x Vy Vz radius of bottom face radius of top face coordinate of the first focus coordinate of the second focus major axis length center coordinate of ellipsoid major axis vector minor axis length coordinate of the top vector to the first triangle face vector to the second triangle face height vector You cannot set R2 to 0 in definition of TRC. If you want to define a usual cone, i.e. not truncated cone, using TRC, you should set R2 to a small value.
