Download User Manual - GS Global Resources

5.0
OPTIONAL PROGRAMMING WITH RCP
Using the optional RCP software makes programming of the Flex VUE™ easier and allows for settings to
be saved for future reference.
WARNING
THE USE OF RCP (RADIO CONTROL PROGRAMMER) IS INTENDED FOR USE BY AUTHORIZED PERSONS
ONLY. CHANGES TO ANY RADIO DATA VALUE MAY LEAD TO UNEXPECTED, UNDESIRABLE, OR UNSAFE
OPERATION OF EQUIPMENT AND FURTHERMORE MAY LEAD TO EQUIPMENT DAMAGE, PERSONAL
INJURY, OR EVEN DEATH. ALL EQUIPMENT OPERATORS AND/OR PERSONNEL SHOULD BE NOTIFIED OF
ANY RADIO DATA VALUE CHANGES THAT MAY AFFECT OPERATION.
5.1
ACCESS CODES
The receiver and transmitter must be programmed with the same access code to properly communicate
with each other.
WARNING
TWO OPERATIONAL TRANSMITTERS WITH THE SAME ACCESS CODES OPERATING AT THE SAME TIME IS
A DEFINITE SAFETY HAZARD. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY
OR DEATH AND DAMAGE TO EQUIPMENT.
5.2
CONNECTING THE FLEX VUE™ TO A COMPUTER
The Flex VUE™ transmitter contains circuitry that permits communication with a computer system via
USB. The USB mini-B plug is located through the battery compartment.
July 2013
Page 25 of 41
Flex VUE™ Transmitter Instruction Manual