Download Crow

PARTITION KEYPAD OPTIONS
PARTITION A - P299E default 1-8
PARTITION B - P399E default 1-8
PARTITION C - P499E default 1-8
P300E (default none)
P400E (default none)
P500E (default none)
P299E
"ARM" key can disarm during exit delay - This option enables the one key disarm during exit delay
feature on a keypad by keypad basis with Partition boundaries . Options 1-8 represent keypads 1-8
P300E
"STAY" key can disarm during Monitor Mode - This options enables single button disarm of Stay
mode via the "STAY" key. Options 1-8 represent keypads 1-8
Note: P399E & P400E are as above but apply to keypads in Area B
Note: P499E & P500E are as above but apply to keypads in Area C
PROGRAMMING PARTITION PARAMETERS
PARTITION "A" TIME ZONE AUTO ARM/DISARM OPTIONS - P290E
PARTITION "B" TIME ZONE AUTO ARM/DISARM OPTIONS - P390E
PARTITION "C" TIME ZONE AUTO ARM/DISARM OPTIONS - P490E
A Time Zones
- - - - - - - P290E
1-8
Time Zone to use for Auto Arm or Disarm (Default 0) - This option will determine which Time
Zone/s will cause Area "A" to arm, disarm or both, based on the programmed options set at
P303E for Area A.
Note: P390E is the same as above but applies to Area B Time Zone Arm/Disarm
Note: P490E is the same as above but applies to Area C Time Zone Arm/Disarm
PARTITIONS TIME AND DELAY OPTIONS
PARTITION "A" - P303E
PARTITION "B" - P403E
PARTITION "C" - P503E
P303E
1E Set partition when time zone ends -Default off
2E Unset partition when time zone starts - Default off
3E Disable stay mode exit delay - Default off
4E Disable set mode exit delay - Default off
5E Disable stay mode entry delay - Default off
6E Disable set mode entry delay - Default off
7E Use special stay mode entry delay - Default off
8E Send alarms and bypasses in stay mode - Default on
A Misc Options 3
- - - - - - - 8
Option 1
Set partition when time zone ends - this option will automatically arm partition "A" when the
time zone programmed at address P290E finishes.
Option 2
Unset partition when the time zone starts - this option will automatically disarm partition "A"
when the time zone programmed at address P290E starts.
Option 3
Disable stay mode exit delay - If this option is on the exit delay for partition "A" becomes “0”