Download User Manual - CNET Content Solutions

A flash utility enables you to update hardware and server firmware and eliminates
the need to manually install new firmware or firmware updates from a physical
diskette or other medium. To find a flash utility, complete the following steps:
1. Go to http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=SERVXPRESS.
2. Download IMM, uEFI, pDSA code from http://www-933.ibm.com/support/
fixcentral/.
3. Follow IMM, uEFI, pDSA readme file for firmware update
Resetting the IMM2 with the Setup utility
To reset the IMM2 through the Setup utility, complete the following steps:
1. Turn on the server.
Note: Approximately 60 seconds after the server is connected to ac power, the
power-control button becomes active.
2. When the prompt F1 Setup is displayed, press F1. If you have set both a
power-on password and an administrator password, you must type the
administrator password to access the full Setup utility menu.
3. 3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. Select Reset IMM.
Note: After you reset the IMM2, this confirmation message is displayed
immediately:
IMM2 reset command has been sent successfully!! Press ENTER to continue.
The IMM2 reset process is not yet complete. You must wait
approximately 3 minutes for the IMM2 to reset before the IMM2 is
Chapter 3. Configuring the server
61