Download USER`S MANUAL
Transcript
4. Tip: Avoid pinching the Main Wire (60). Insert the Upright (5) into the Main Frame (1). 4 Attach the Upright (5) with four M8 x 16mm Screws (102) and four M8 Split Washers (103); do not tighten the Screws yet. You will tighten the Screws at the end of step 11. Avoid pinching the Main Wire (60) 5 102 103 102 103 1 102 103 102 5. Using a small plastic bag to keep your fingers clean, apply a coat of the included grease to the Upright Axle (48) and to two Wave Washers (118). 5 102 118 Insert the Upright Axle (48) through the Upright (5) and center it. Then, slide a Wave Washer (118) onto each side of the Upright Axle. 5 7 Next, identify the Right and Left Upper Body Legs (6, 7), which are marked with “Right” and “Left” stickers, and orient them as shown. Slide the Right and Left Upper Body Legs (6, 7) onto the Upright Axle (48). Then, tighten an M8 x 16mm Screw (102) and an M8 Washer (95) into each end of the Upright Axle (48) at the same time. 95 48 Grease 118 95 102 6 8